US 250GN

Geonet

An HDPE Geonet.

PROPERTY TEST METHOD UNIT REQUIRED VALUE QUALIFIER
Thickness ASTM D-5199 mil
250±15
Range
Carbon Black Content ASTM D-4218 %
2 to 3
Range
Tensile Strength ASTM D-5035 lb/in
50
Minimum
Melt Flow ASTM D-1238 (Condition 190/2.16) g/10 min
1
Maximum
Density ASTM D-1505 g/cm3
0.94
Minimum
Transmissivity ASTM D-4716 m2/sec
2.5x10-3
MARV

Notes:
Transmissivity measured using water at 21 ± 2°C (70 ± 4°F) with a gradient of 0.1 and a confining pressure of 1000 psf between stainless steel plates after 15 minutes. Values may vary between individual labs.

MARV is statistically defined as mean minus two standard deviations and it is the value which is exceeded by 97.5% of all the test data.

The above information is to the best of our knowledge accurate, but it is not intended to be considered a guarantee. Any implied warranty for a particular use or purpose is excluded. If the product does not meet the above properties, and notice is given to US Fabrics, Inc., the product will be replaced or refunded (1/2012).